EasyManua.ls Logo

Toro Greensmaster Flex21 04021 - Fuel System Maintenance; Electrical System Maintenance; Drive System Maintenance

Toro Greensmaster Flex21 04021
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fuel System
Maintenance
Cleaning the Fuel Filter
Initially , clean fuel filter after the first 25 hours of
operation; thereafter clean after ev er y 50 hours
operation.
1. Close fuel shut off v alv e and unscrew bo wl from
filter body ( Figure 25 ).
Figure 25
1. Shut-off valve 2. Bowl
2. Clean bo wl and filter in clean g asoline and install.
Electrical System
Maintenance
Servicing the Interlock
Switch
Use the follo wing procedure should the switc h need
adjustment or re placement.
1. Mak e sure the engine is off and traction lev er is
Diseng ag ed.
2. Eng ag e traction lev er until it contacts neutral stop
( Figure 26 ).
Figure 26
1. Traction lever 3. Interlock switch
2. Neutral stop
4. .032" Gap
3. Loosen interloc k switc h mounting fasteners
( Figure 26 ).
4. Place a .032" thic k shim betw een the traction lev er
and the interloc k switc h ( Figure 26 ).
5. Tighten interloc k switc h mounting fasteners .
R ec hec k g ap . T he traction lev er m ust not contact
the switc h.
6. Eng ag e traction lev er and v erify that the switc h
loses contin uity . R e place if required.
Important: R eplace inter lock s witch ev er y
2 y ear s.
Drive System
Maintenance
Checking the Transmission
Fluid Level
T he transmission is filled at the factor y with
appro ximately 94 fluid ounces of Mobil Dexron lll
automatic transmission fluid. Chec k fluid lev el before
the engine is first star ted and ev er y 50 hours thereafter .
Note: T he seals used in the transmission are inter nally
lubricated with g rease . During initial operation of
mo w er , slight w ee ping of g rease from these seals will
occur . Wipe off ex cess g rease .
Important: Use onl y Mobil Dexr on lll or
equi v alent transmission fluids. Other fluids could
cause system dama ge.
1. Place the mo w er on its dr ums on a lev el surface .
2. R emo v e the c hec k/fill plug from the right-hand
side of the transmission ( Figure 27 ).
23

Table of Contents

Related product manuals