Toro Greensmaster Flex21 04021 - Setup; Installing the Handle

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
Handle
1
Install the handle.
2
No parts required
–
Adjust the handle.
3
Transport wheels (Optional Transport
Wheel Kit, Model 04123)
2
Install the transport wheels.
4
No parts required
–
Check the engine oil and transmission
uid levels
5
Grass basket
1
Install the grass basket.
Operator’s Manual
1
Engine Operator’s Manual
1
Parts Catalog
1
Operator Video
1
6
Certicate of compliance
1
Read the manuals and watch the video
before operating the machine.
Note: Deter mine the left and right sides of the
mac hine from the nor mal operating position.
Step
1
Installing the Handle
Parts needed for this step:
1
Handle
Procedure
1. R emo v e the flang e loc k n ut from the capscrew and
pi v ot pin on eac h side of the mo w er ( Figure 4 ).
Figure 4
1. Flange lock nut
2. Pivot pin
2. Inser t the handle ends through the slots in the
handle suppor t ar ms ( Figure 5 ).
9