Toro Groundsmaster 3505-D - Blade Spindle

Rev. A
Groundsmaster 3505--DPage 7 -- 12Cutting Units
Blade Spindle
1. Socket head screw (2 per motor)
2. Flat washer (2 per motor)
3. Hydraulic deck motor
4. O--ring
5. Flange nut (6 used)
6. Spindle plate
7. Cutting deck
8. Spindle assembly
9. Cap screw (6 used)
10. Cutting blade
11. Anti--scalp cup
12. Blade bolt
Figure 13
FRONT
RIGHT
6
11
8
9
7
12
10
3
5
4
2
1
88 to 108 ft--lb
(119 to 146 N--m)
Removal (Fig. 13)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove two (2) socket head screws and flat wash-
ers that secure hydraulic motor to the cutting unit (Fig.
14). Remove hydraulic motor from deck. Locate and re-
trieve o--r ing from top of spindle housing.
3. Cover top of spindle to prevent contamination.
Spindle plug (Toro Part # 94--2703) can be used to cover
spindle.
4. Start the engine and raise the cutting unit. Stop en-
gine and remove key from the ignition switch. Support
the cutting unit so it cannot lower a ccidentally. If required
for easier service, remove cutting unit from machine
(see Cutting Unit Operator’s Manual).
5. Remove cutting blade bolt, anti--scalp cup and cut-
ting blade (see Cutting Unit Operator’s Manual).
6. Remove six (6) cap screws and flange nuts s ecuring
spindle housing to deck. Lower spindle assembly out
the bottom of the deck. Remove spindle plate from top
of deck.