Groundsmaster 3505--DPage 3 -- 6Kubota Diesel Engine
Air Cleaner Assembly Removal (Fig. 1)
NOTE: See Traction Unit Operator’s Manual for air
cleaner maintenance procedures and intervals.
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch. Unlatch and raise hood.
2. Remove air cleaner components as needed using
Figure 1 as a guide.
3. Check air cleaner body for damage that could cause
possible air leaks. Make sure that dust cup seals com-
pletely to the air cleaner body.
Air Cleaner Assembly Installation (Fig. 1)
IMPORTANT: Any leaks in the air filter system will
allow dirt into engine and will cause serious engine
damage. Make sure that all air cleaner components
are in good condition and are properly secured dur-
ing assembly.
1. Assemble air cleaner system using Figure 1 as a
guide. Make sure that vacuator valve is pointed down af-
ter assembly (Fig. 3).
2. Close and latch hood.
Figure 3
1. Latch
2. Dust cup
3. Vacuator valve
2
1
3
To Next Page
Loading...
