Toro Groundsmaster 4300-D - Setup - Part 4; Adjusting Carrier Frame; Adjusting Front Cutting Units

g003946
Figure7
1.Nut3.Hoodlatch
2.Metalwasher4.Rubberwasher
4.Ontheoutsideofthehood,insertthehookend
ofthelatchthroughtheholeinthehoodand
ensurethattherubber-sealingwasherremains
totheoutersideofthehood(Figure7).
5.Ontheinsideofthehood,insertthemetal
washerontothelatch,securethelatchwiththe
nut,andensurethatthelatchengagestheframe
catchwhenitislocked.
Note:Usetheenclosedhood-latchkeyto
operatethehoodlatch.
6
AdjustingtheCarrierFrame
NoPartsRequired
AdjustingtheFrontCuttingUnits
Thefrontandrearcuttingunitsrequiredifferent
mountingpositions.Thefrontcuttingunithas2
mountingpositionsdependingonwhatheightofcut
anddegreeofcuttingunitrotationyoudesire.
•Forheightsofcutbetween2.0to7.6cm(0.75to3
inches),mountthefrontcarrierframesinthelower
frontmountingholes(Figure8).
Note:Thispositionallowsmoreforward
positioningofthecuttingunitsrelativetothe
tractionunitwhenapproachingquickuphill
changesinterrain.However,itdoeslimitthe
clearanceofthechambertothecarrierwhen
crestingsharpknolls.
g011343
Figure8
1.Front-cutting-unit
mountinghole(upper)
3.Rear-cutting-unitmounting
hole
2.Front-cutting-unit
mountinghole(lower)
•Forheightsofcutbetween6.3to10cm(2.5to4
inches),mountthefrontcarrierframesintheupper
frontmountingholes(Figure8).
Note:Thisincreasesthechambertocarrier
clearanceduetothehigherpositionofthecutting
chamber,butwillcausethecuttingunitstoreach
theirmaximumforwardtravelsooner.
14