8
Engine Oil Change Procedure
1. Run engine to warm engine oil.
2. Remove spark plug cap from the spark plug.
NOTE: Ensure fuel system contains no fuel to prevent leakage when the mower is tipped onto its side.
3. Remove the dipstick.
4. Tip the mower onto side with the dipstick on the downward side. Drain the used oil through the oil fill tube
into a suitable container.
5. Return the mower to the operating position.
6. Add oil through the dipstick tube. Wipe the dipstick clean an insert it into the dipstick tube to check the oil
level.
NOTE: DO NOT screw the dipstick into the dipstick tube to check the oil level
NOTE: DO NOT overfill the engine oil
7. Fully Install the dipstick and hand tighten it securely.
8. Properly dispose of the used engine oil.
Engine Oil Capacity:
Max. fill: 20 oz (0.59 l)
Engine Oil Type:
SAE 30 or 10W-30 detergent oil. API classification of SF,SG, SH, SJ, SL, or higher.
To Next Page
Loading...
Need help?
General
