Toro LX500 - Page 153

GLOSSARY
'HP\VWL¿FWLRQ*ORVVDU\  
GLOSSARY
7HVWLQJWKH50&V\VWHP±0DQXDO372NH\VZLWFK
LQ³5HYHUVH&DXWLRQ´8QDFWLYDWHG,QGLFDWRUOLJKW
RII
1. Start the engine; place the keyswitch in the reverse
caution position.
2. With the seat occupied, place the PTO lever in the
“on” position.
3. With the brake applied, move the shift lever to the
reverse position.
4. The engine should shut down.
7HVWLQJWKH50&V\VWHP±0DQXDO372NH\VZLWFK
LQ³5HYHUVH&DXWLRQ´$FWLYDWHG,QGLFDWRUOLJKWRQ
1. Start the engine; place the keyswitch in the reverse
caution position.
2. Press the reverse push button.
3. With the seat occupied, place the PTO lever in the
“on” position.
4. With the brake applied, move the shift lever to the
reverse position.
5. The engine should continue to run.
7HVWLQJWKH50&V\VWHP±(OHFWULF372NH\VZLWFK
LQ³1RUPDO´
1. Start the engine; place the keyswitch in the normal
position.
2. With the seat occupied, pull the PTO switch to the
“on” position.
3. With the brake applied, move the shift lever to the
reverse position.
4. The electric clutch should disengage.
5. Place the shift lever in forward.
6. The electric clutch should remain disengaged.
7. Cycle the PTO switch off and on.
8. The electric clutch should re-engage.
7HVWLQJWKH50&V\VWHP±(OHFWULF372NH\VZLWFK
LQ³5HYHUVH&DXWLRQ´8QDFWLYDWHG,QGLFDWRUOLJKW
RII
1. Start the engine; place the keyswitch in the reverse
caution position.
2. With the seat occupied, pull the PTO switch to the
“on” position.
3. With the brake applied, move the shift lever to the
reverse position.
4. The electric clutch should disengage.
5. Place the shift lever in forward.
6. The electric clutch should remain disengaged.
7. Cycle the PTO switch off and on.
8. The electric clutch should re-engage.
7HVWLQJWKH50&V\VWHP±(OHFWULF372NH\VZLWFK
LQ³5HYHUVH&DXWLRQ´$FWLYDWHG,QGLFDWRUOLJKWRQ
1. Start the engine; place the keyswitch in the reverse
caution position.
2. Press the reverse push button.
3. With the seat occupied, pull the PTO switch to the
“on” position.
4. With the brake applied, move the shift lever to the
reverse position.
5. The electric clutch should remain engaged.