How to remove the battery pack from my Toro Trimmer if it is difficult?
If it's difficult to remove the battery pack from your Toro Trimmer, it may be due to the tool or battery being new, or corrosion in the terminals. Clean the terminals on both the battery pack and the tool, then apply dielectric grease to the battery terminals. Do not use other lubricants.
How to fix excessive vibration or noise from my Toro PowerPlex?
If your Toro Trimmer is producing excessive vibration or noise, consider the following: * There may be debris on the drum area. Clean off any debris. * The spool might not be wound correctly. Try advancing the line using the trigger switch, or remove the line and rewind the spool.
What to do if my Toro Blower does not run or runs continuously?
If your Toro Blower isn't running or runs without stopping, there might be a few reasons. First, check the battery pack leads for moisture and allow them to dry or wipe them. Second, make sure the battery is fully installed and latched in the tool. Finally, the battery pack may be low on charge, so charge it fully.
Keep the work area clean and well lit. Avoid dangerous environments and wet locations.
Stay alert, use PPE, prevent unintentional starting, do not overreach, dress properly, keep hands and feet away from cutting area.
Do not force the tool, use it correctly, remove battery before adjustments, store properly, maintain tools.
Have power tool serviced by a qualified repair person using only identical replacement parts.
Do not charge or use appliance in rain. Use only specified battery types. Handle batteries with care.
Procedure to securely mount the battery charger on a wall using wall-mount key holes.
Procedure to unfold and assemble the trimmer handle to the desired height.
Procedure to align and snap the auxiliary handle onto the trimmer handle.
Procedure to remove screws, slide guard onto trimmer base, and secure with screws.
Procedure to spread wire edge guard ends and insert them into trimmer housing holes.
Appropriate temperature ranges for charging, using, and storing the product.
Ensure vents are clear, align battery cavity with tongue, push battery pack until latched, press lockout button, squeeze trigger.
To shut off the trimmer, release the trigger. Remove battery pack when not using or transporting.
Press the battery latch to release the battery pack and slide it out of the machine.
Charge battery within temperature range. Ensure vents are clear, align cavity, slide pack into charger.
Auto-feed: release trigger, wait, press lockout, squeeze trigger. Manual feed described later.
Remove battery, push button at spool retainer base, pull trimmer line to advance.
Loosen connector, slide shaft to desired position, tighten connector. Do not slide upper shaft over vents.
Release latch, slide handle up/down, close latch to secure. Do not remove rubber bumper.
Illustration of proper trimming technique, showing tool angle and cutting path.
Procedure to remove the spool retaining cover, replace spool, and thread string into the eyelet.
Procedure to replace the string, wind it onto the spool, and secure it.
Store tool, battery, and charger in appropriate temperatures, out of reach of children and away from corrosive agents.
Cover terminals with tape, do not disassemble. Recycle or dispose of at a facility.
To Next Page
General