Toro Pro Force Groundsmaster 3280-D - Replacing the CV Shaft

DANGER
DonotstarttheengineandengagethePTO
leverwhenthePTOshaftisnotconnectedto
thegearboxontheattachment.
IftheenginestartsandthePTOshaftrotates,
seriousinjurycouldresult.
2
ReplacingtheCVShaft
Partsneededforthisprocedure:
2
Bolt(3/8–16x1–3/4inches)
2
Locknut(3/8–16inch)
1
CVdriveshaft
1
Rollpin(3/16x2–1/4inches)
Procedure
1.Removetheexistingdriveshaftfromthe
machine.
2.PlacethenewCVdriveshaftinthelocationof
theoldoneandsecureitwith2bolts(3/8–16x
1–3/4inches),2locknuts(3/8–16inch),anda
rollpin(3/16x2–1/4inches).
g029541
Figure2
1.Existingdriveshaft4.Bolt(3/8–16x1–3/4
inches)
2.CVdriveshaft5.Rollpin(3/16x2–1/4
inches)
3.Locknut(3/8–16inch)
3.Torquetheboltsandlocknutsto51to65N⋅m
(38to48ft-lb).
4.GreasetheCVshaftatallrecommendedgrease
points;refertoyourattachmentOperator’s
Manual.
3