Storing the Machine in the
V ertical-Stow Position
Y ou can store your machine in the vertical position to
minimize storage space.
DANGER
The vertical-stow position exposes the bottom
of the machine.
• Remove the battery pack and the
electric-start button before moving the
machine into the vertical-stow position.
• Do not transport the machine in the
vertical-stow position.
• Do not attempt to start the machine in the
vertical-stow position.
1. Remove the electric-start button and battery
from the machine.
2. Ensure that the cutting-height setting on the
machine is 44 mm (1-3/4 inches) or higher; if
it is not, raise it; refer to Adjusting the Cutting
Height ( page 13 ) .
3. Disengage the handle locks and fold the handle
fully forward; refer to Folding the Handle ( page
17 ) .
Important: Route the cables to the outside
of the handle locks as you fold the handle.
4. Engage the handle locks.
5. Lift the front of the machine by the handle and
move it into a storage space ( Figure 17 ).
g409126
Figure 17
18
To Next Page
Loading...
