Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1. T urn the adjustment nut counterclockwise to
loosen the cable adjustment ( Figure 20 ).
g427094
Figure 20
1. Electric-start switch 4. T urn the nut
counterclockwise to
loosen the adjustment.
2. Self-propel-drive cable
5. T urn the nut clockwise to
tighten the adjustment.
3. Adjustment nut
2. Adjust the tension on the cable ( Figure 20 ) by
pulling it back or pushing it forward and holding
that position.
Note: Push the cable toward the motor to
increase the traction; pull the cable away from
the motor to decrease the traction.
3. T urn the adjustment nut clockwise to tighten the
cable adjustment.
Note: T ighten the nut rmly with a socket or
wrench.
Preparing the Battery Pack
for Recycling
Important: Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
Lithium-ion battery packs labeled with the
Call2Recycle seal can be recycled at any
participating retailer or battery recycling
facility in the Call2Recycle program (US
and Canada only). T o locate a participating
retailer or facility closest to you, please call
1-800-822-8837 or visit www .call2recycle.org.
If you cannot locate a participating retailer or
facility nearby , or if your rechargeable battery
is not labeled with the Call2Recycle seal,
please contact your local municipality for more
information on how to responsibly recycle the
battery . If you are located outside of the US
and Canada, please contact your Authorized
Service Dealer .
20
To Next Page
Loading...
