EasyManua.ls Logo

Toro Recycler 21327 - Page 23

Toro Recycler 21327
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem
Possible Cause Corrective Action
1. There is an error in the communication
between the battery pack and the
charger .
1. Remove the battery pack from the
battery charger , unplug the battery
charger from the outlet, and wait 10
seconds. Plug the battery charger into
the outlet again and place the battery
pack on the battery charger . If the LED
indicator light on the battery charger is
still blinking red, repeat this procedure
again. If the LED indicator light on
the battery charger is still blinking red
after 2 attempts, properly dispose of
the battery pack at a battery recycling
facility .
The LED indicator light on the battery
charger is blinking red.
2. The battery pack is weak.
2. Contact your Authorized Service
Dealer if the battery is in warranty , or
properly dispose of the battery pack at
a battery recycling facility .
1. The battery pack is not charged.
1. Remove the battery pack from the
machine and charge it.
2. The machine is in an unsafe position
for operation.
2. Ensure that the machine is not at an
extreme angle while operating.
3. The machine is overloaded.
3. Cut the grass at a higher height of cut
or walk at a slower pace while mowing.
The machine is producing a beeping
sound.
4. There is another electrical problem
with the machine.
4. Attempt the other troubleshooting
actions, if the alarm still sounds,
contact an Authorized Service Dealer .
1. The blade is dull. 1. Have the blade sharpened or replaced.
The quality of cut is decreased or
unsatisfactory .
2. The cutting deck has debris buildup.
2. Clean under the machine.
1. The machine is overloaded.
1. Cut the grass at a higher height of cut.
The bagging is decreased or
unsatisfactory .
2. The bag has debris buildup.
2. Clean the inside of the bag of any dust
or debris.
1. The blade is dull. 1. Have the blade sharpened or replaced.The machine is cutting unevenly .
2. The cutting deck is damaged.
2. Contact an Authorized Service Dealer .
The machine is vibrating. 1. The blade is bent or damaged.
1. Inspect the blade and replace if
necessary .
23

Related product manuals