g189232
Figure 20
5. After draining the used oil, return the machine to
the operating position.
6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-ll tube.
7. W ait 3 minutes for the oil to settle in the engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-ll tube, screw it
in , then remove the dipstick.
10. Read the oil level on the dipstick ( Figure 19 ).
• If the oil level on the dipstick is too low ,
carefully pour a small amount of oil into the
oil-ll tube, wait 3 minutes, and repeat steps
8 through 10 until the oil level on the dipstick
is correct.
• If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important: If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
1 1. Install the dipstick into the oil-ll tube securely .
12. Recycle the used oil properly .
Replacing the Blade
Service Interval : Y early
Important: Y ou will need a torque wrench to
install the blade properly . If you do not have a
torque wrench or are uncomfortable performing
this procedure, contact an Authorized Service
Dealer .
Examine the blade whenever you run out of fuel. If the
blade is damaged or cracked, replace it immediately .
If the blade edge is dull or nicked, have it sharpened
and balanced, or replace it.
W ARNING
The blade is sharp; contacting the blade can
result in serious personal injury .
W ear gloves when servicing the blade.
1. Refer to Preparing for Maintenance ( page 17 ) .
2. T ip the machine onto its side with the air lter up.
3. Use a block of wood to hold the blade steady
( Figure 21 ).
g231389
Figure 21
4. Remove the blade, saving all mounting hardware
( Figure 21 ).
5. Install the new blade and all mounting hardware
( Figure 22 ).
19
To Next Page
Loading...
