Toro Reelmaster 5500-D - Controls - System Operation; Key Switch, Throttle, and Enable;Disable; Reel Speed and Backlap Controls

Controls
– 16 –
Figure 10
1. Lower mow/raise control lever
2. Speedometer
3. Fuel gauge
4. Engine coolant temperature gauge
5. Engine oil pressure warning light
6. Engine coolant temperature warning light.
7. Glow plug indicator light
8. Charge indicator
9. Key switch
10. Throttle control
11. Enable/Disable switch
Charge Indicator (Fig. 10)—Illuminates when
system charging circuit malfunctions.
Key Switch (Fig. 10)—Three positions: OFF,
ON/Preheat and START.
Throttle Control (Fig. 10)—Move the control
forward to increase engine speed, rearward to
decrease speed.
Enable/Disable Switch (Fig. 10)—Used with lower
mow/raise control lever (Joystick) to operate reels.
Reels can be raised, but not lowered, when in mid
position.
Backlap Knobs (Fig. 11)—Used with lower
mow/raise control lever for backlapping operation.
Refer to Cutting Unit Maintenance, Backlapping.
Figure 11
1. Reel speed controls
2. Backlap knobs
Reel speed Controls (Fig. 11)—Control rpm of the
front and rear cutting units. The #1 position is for
backlapping. The remaining settings are for
mowing operations.
10
3
2
9
4
8
11
5
6
7
1
1
1
2
2