– 24 –
Maintenance
Maintenance Procedure Maintenance Interval & Service
✝ Initial break in at 10 hours
‡ Initial break in at 50 hours
Change hydraulic fluid
✝ Change transmission fluid
✝ Replace transmission filter
Check rear wheel toe-in
Rear axle service
– pack rear wheel bearings (2WD)
– change rear axle lubricant (4WD)
Replace moving hydraulic hoses
Replace safety switches
Flush the cooling system and replace fluid
Drain and flush the fuel tank
Drain and flush the hydraulic tank
Service the air cleaner (if indicator shows red)
Replace the fuel filter
Inspect traction linkage movement
‡ Torque cylinder head bolts and adjust valves
‡ Check engine rpm (idle and full throttle)
Drain moisture—hydraulic tank
Drain moisture—fuel tank
Check reel bearing preload
✝Torque wheel lug nuts
‡ Replace engine oil filter
✝ Check fan and alternator belt tension
Inspect cooling system hoses
Check battery fluid level
Check battery cable connections
Lubricate all grease fittings
Change engine oil
Inspect air filter, dust cap and baffle
Every
400
hours
Every
800 hours
Every
200
hours
Every
100
hours
Every
50
hours
Minimum Recommended Maintenance Intervals
Recommendations:
Items are recommended every 1600 hours or
two years, whichever occurs first.
To Next Page
Loading...
