Engine: Kubota three-cylinder, 4-cycle, liquid-
cooled diesel. 26kW (35 hp) @ governed to 3200
rpm; 1123 cc displacement. Heavy-duty, 3-stage,
remote-mounted air cleaner. High water
temperature shutdown switch.
Main Frame: All welded formed steel frame,
includes three tie-down loops
Cooling System: Radiator capacity is 7.1 l of 50/50
mixture of ethylene glycol anti-freeze. Remote
mounted 0.95L expansion tank. Removable oil
cooler/radiator intake screen. Air-to-oil cooler,
mounted to front of radiator, tips forward for
cleaning
Fuel System: Fuel tank capacity is 37.9 l (10 gal.)
of #2 diesel fuel. Equipped with a fuel filter/water
separator to capture water in the fuel.
Traction System: Foot pedal controls forward/
reverse ground speed. Ground speed: 0–16.1 kmh
(0–10 m.p.h.) forward and 0–6.4 kmh (0-4 mph)
reverse. Hydrostatic transmission mounted directly
on a 20.9:1 ratio front axle. Axle/reservoir capacity
is 4.7 l (5 qts). Replaceable filter mounted directly
on transmission housing. Model 03551—
Mechanical rear axle is coupled to the front axle by
a drive shaft and overrunning clutch.
Cutting Unit Drive System: Hydraulic reel motors
feature quick disconnects to ease removal/
installation on cutting units. Hydraulic fluid
reservoir capacity is 32.2 l (8.5 gal.). System
protected by a filter assembly with service indicator.
Seat: Deluxe high back seat with adjustable fore
and aft travel, weight and height. Tool box at the
left side of the seat.
Steering System: Power steering with dedicated
power source.
Tires: Two rear tires: 20 x 10-8, tubeless, 6-ply
rating. Two front tires: 26 x 12.00-12 tubeless, 4-
ply rating. Recommended tire pressure for the
front and rear tires is 69–103 kPa (10–15 psi).
Brakes: Individual drum-type wheel brakes on the
front traction wheels. Brakes are controlled by
individual pedals operated by the left foot.
Hydrostatic braking through the traction drive.
Electrical System: Automotive-type electrical
system. 12-volt, maintenance-free battery with 530
cold cranking Amps @ –17° C and 85 minute
reserve capacity @ 29° C. 40-amp alternator with
I.C. regulator/rectifier. Seat switch, reel and traction
interlock switches. An electronic controller
monitors and controls safety and operational
functions. Parking brake switch and individual
circuit backlap switches.
Controls: Foot-operated traction and brake pedals.
Hand-operated throttle, traction speed control lever,
parking brake lock, ignition switch with automatic
preheat cycle, single joy stick control for cutting
unit on/off and lift/lower. Cutting unit backlap
switch and reel speed controls located under the
operator seat.
Gauges: Hour meter, speedometer, fuel gauge,
temperature gauge. 4 warning lamps: oil pressure,
water temperature, amps and glow plug.
Diagnostics: The Automatic Control Electronics 7
ACE™ system allows precise timing and control of
machine functions for maximum reliability.
Optional hand-held diagnostic display connects to
an electronic control unit to pin point any electrical
problems quickly and easily. Available DATA
LOG™ system allows mechanic to find intermittent
problems.
General Specifications (approx.):
Width-of-Cut : 254 cm (100 in.)
Overall Width:
Transport 222.5 cm (88 in.)
Outside of front tires 221 cm (87 in.)
Outside of rear tires 133.3 cm (52.5)
Overall Length:
Without grass baskets: 287 cm (113 in.)
With grass baskets: 305 cm (120 in.)
Height:
With Rollover protector: 208 cm (82 in.)
Without 150 cm (59 in.)
9
Specifications
To Next Page
Loading...
