Toro Reelmaster 5510 Series - Adjusting the Rear Roller; Adjusting the Rear Spacers

AdjustingtheRearRoller
1.Adjusttherearrollerbrackets(Figure11)tothe
desiredheight-of-cutrangebypositioningthe
requiredamountofspacersbelowthesideplate
mountingange(Figure11)pertheheight-of-cut
chart;refertoHeight-of-CutChart(page12).
g003324
Figure11
1.Spacer3.Sideplatemountingange
2.Rollerbracket
2.Raisetherearofcuttingunitandplaceablock
underthebedknife.
3.Removethe2nutssecuringeachrollerbracket
andthespacertoeachsideplatemounting
ange.
4.Lowertherollerandthescrewsfromtheside
platemountingangesandspacers.
5.Placethespacersontothescrewsontheroller
brackets.
6.Securetherollerbracketandthespacersto
undersideofthesideplatemountinganges
withthenutspreviouslyremoved.
7.Verifythatthebedknifetoreelcontactiscorrect.
Tipthecuttingunittoexposefrontandrear
rollersandthebedknife.
Note:Thepositionoftherearrollertothereel
iscontrolledbythemachiningtolerancesofthe
assembledcomponents,andsoparallelingis
notrequired.Alimitedamountofadjustmentis
possiblebysettingthecuttingunitonasurface
plateandlooseningthesideplatemountingcap
screws(Figure12).Adjustandtightenthecap
screws.T orquethecapscrewsto27to36N∙m
(240to320ft-lb).
g020552
Figure12
1.Sideplatemountingcapscrews
AdjustingtheRearSpacers
Thenumberofrearspacersdeterminesthe
aggressivenessofcutforthecuttingunit.Foragiven
heightofcut,addingspacers,belowthesideplate
mountingange,increasestheaggressivenessofthe
cuttingunit.Allcuttingunitsonagivenmachinemust
besettothesameaggressivenessofcut(Number
ofrearspacers,PartNo.106-3925);otherwise,the
after-cutappearancecouldbenegativelyaffected
(Figure17).
PositioningtheChainLinks
Thelocationatwhichtheliftarmchainisattached
determinestherearrollerpitchangle(Figure13).
g006503
Figure13
1.Liftchain
3.Bottomhole
2.U-backet
10