Hauling the Machine (continued)
Trailer Requirements
WARNING
Loading a machine onto a trailer or truck increases the possibility of tip-over and
could cause serious injury or death.
• Use only a full-width ramp; do not use individual ramps for each side of the
machine.
• Do not exceed a 15-degree angle between the ramp and the ground or between the
ramp and the trailer or truck.
• Ensure that the length of ramp is at least 4 times as long as the height of the trailer
or truck bed to the ground.
G027996s
Full-width ramp(s) in stowed
position
Side view of full-width ramp in
loading position
Not greater than 15 degrees
Ramp is at least 4 times as long as
the height of the trailer or truck bed to
the ground
H = height of the trailer or truck bed
to the ground
Trailer
Operation: After Operation Page 4–18 3464-625 A
To Next Page
Loading...
