What to do if my Toro TimeCutter MX 4260 starter does not crank?
If the starter on your Toro Lawn Mower isn't cranking, try these steps: Ensure the blade control switch is disengaged. Verify that the motion control levers are in the park position. If the battery is dead, charge it. Check the electrical connections for corrosion or looseness, ensuring good contact. Finally, inspect the fuse and replace it if blown.
How to stop abnormal vibration in my Toro TimeCutter MX 4260?
To address abnormal vibration in your Toro Lawn Mower, check the following: Tighten any loose engine mounting bolts. Ensure the engine pulley, idler pulley, or blade pulley are tightened appropriately. Replace the cutting blade(s) if they are bent or unbalanced. Also, tighten any loose blade mounting bolts.
What to do if the blades on my Toro TimeCutter MX 4260 Lawn Mower do not rotate?
If the blades on your Toro Lawn Mower aren't rotating, check if the drive belt is worn, loose, or broken, and install a new drive belt if necessary. Also, ensure the drive belt is properly positioned on the pulley, and check the adjusting shafts and belt guides for correct positioning. Finally, check if the mower belt is worn, loose, or broken and install a new mower belt if needed.
General| Cutting Width | 42 inches |
|---|---|
| Deck Material | 10-gauge steel |
| Fuel Capacity | 3 gallons |
| Transmission | Hydrostatic |
| Warranty | 3-year limited |
| Cutting Height | 1.5 - 4.5 inches |
| Speed Range | 0 - 7 mph |
Covers introduction, safety alerts, and basic operating practices for safe use.
Locate and record the product model and serial numbers for service and information.
Includes safe operation, slope use, children, towing, and fuel handling guidelines.
Covers Toro's safety advice, battery handling, and transport precautions.
Visual indicator and instructions for safe operation on slopes.
Understanding and identifying safety decals on the machine.
Diagram identifying key parts of the mower.
Details on motion levers, ignition, throttle, choke, and blade controls.
Covers starting, driving, stopping, adjusting height, and general operation.
Advice on cutting techniques, speed settings, and machine cleaning.
Covers recommended service intervals for engine, fuel, electrical, drive, and mower systems.
Instructions for washing the machine and preparing it for storage.
Guides for resolving engine, drive, and cutting problems.
The electrical system diagram for reference.
To Next Page