3 1
G014476
Figure 21
1. Height-of-cut lever 3. 4.5 inch (115 mm),
Transport position
2. Height-of-cut positions
,
To adjust the height of cut, pull upward and in the
lever then move it to the desired position.
Models with 50 inch Decks
While sitting in the operator's position, raise the seat
adjustment lever slightly and move the seat forward or
backward to the desired position (Figure 23).
\
_f
G014969
Figure 23
Adjusting the Motion Control
Levers
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
Models with 42 inch Decks
,
Raise the seat and loosen the adjustment bolts just
enough that seat can move (Figure 22).
/ /
Adjusting the Height
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 24).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 24).
G014970 _I '_<__
Figure 24
1. Control arm shaft 3. Slotted, upper hole
2. Control lever 4. Bolt
1. Adjustment bolt
,
Figure 22
G014477
Move the seat to the desired position and tighten
the bolts.
3. Repeat the adjustment for the opposite control
lever.
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maximum operator comfort.
23
To Next Page
Loading...
