HYDROSTATIC DRIVE SYSTEM
7-12007 - 2008 Titan Z Service Manual
7
Hydro Drive Belt Replacement
Hydro Drive Belt Removal
1. Disconnect the negative battery cable from the
battery.
2. Raise and support the rear end of the machine with
a lift or jack stands.
3. Locate the idler arm assembly on the mower deck.
Pull the arm toward the rear of the machine and
remove the mower deck belt from the idler pulley
(Fig. 361).
4. Remove the mower deck belt from around the
electric PTO clutch. Push the excess deck belt
forward towards the mower deck (Fig. 362).
Fig. 361 IMG-0432a
Fig. 362 IMG-0372
5. Using a spring tool (Toro part number 92-5771),
release the tension from the hydro drive belt idler
arm and remove the hydro drive belt from the idler
arm pulley (Fig. 363).
Fig. 363 IMG-0435
To Next Page
Loading...
