HYDROSTATIC DRIVE SYSTEM
7-412007 - 2008 Titan Z Service Manual
7
Loosen the limiter stop screws that hold the adjust stop.
Move the adjust stop back until the machine drives
straight. Tighten the screws to lock the stop in place.
Adjust handles to make them parallel with each other, if
necessary.
A. Control Arm Shaft C. Limiter Stop Screw (2)
B. Adjust Stop
12. If adjustment is completed, tighten the two jam nuts
against the adjustment rod nut.
13. Install the bolt and nut securing the seat stop cable
to the seat plate (Fig. 502).
If the machine turns right or left when the handles are
evenly pushed forward, adjust on the side opposite the
direction of turn (Fig. 504).
Fig. 502 IMG-0591
Fig. 504 IMG-0610a
14. Remove the seat switch bypass wire and plug the
wire harness connector into the seat safety switch
(Fig. 503).
Fig. 503 IMG-0608
15. Lower the machine to the ground.
Tracking Adjustment
A
B
C
C
To Next Page
Loading...
