HYDROSTATIC DRIVE SYSTEM
7-40 2007 - 2008 Titan Z Service Manual
7
6. Observe the rear tires to see if there is any move-
ment. If the tire is creeping in either direction, a
neutral adjustment is needed (Fig. 498).
Note: A small amount of creep in reverse is OK.
9. Loosen the two jam nuts and turn the adjustment rod
nut (Fig. 500):
A. Counterclockwise rotation shortens the rod and
adjusts for reverse tire movement.
B. Clockwise rotation lengthens the rod for forward
tire movement.
Fig. 498 IMG-0600
Fig. 500 IMG-0606a
10. Start the engine.
11. Operate the left control handle in forward and re-
verse with the engine running at full throttle. Move
the control handle to the neutral out position and
ensure the rear wheel does not move forward or
reverse. Readjust as required (Fig. 501).
Fig. 501 IMG-0607
7. Turn the engine off to stop the engine.
8. If neutral adjustment is needed, go to the steering
rod located between the motion control pivot as-
sembly and the control arm located on the transaxle.
The steering rod has an adjustment rod nut and two
jam nuts (Fig. 499).
Fig. 499 IMG-0604a
To Next Page
Loading...
