HYDROSTATIC DRIVE SYSTEM
7-292007 - 2008 Titan Z Service Manual
7
10. Remove the hydro drive belt from around the trans-
axle pulley and hydro fan (Fig. 457).
9. Using a spring tool (Toro part number 92-5771)
release the tension from the hydro drive belt idler
arm and remove the hydro drive belt from the hydro
drive idler pulley (Fig. 456).
Fig. 456 IMG-0435
Fig. 457 IMG-0552a
11. Remove the carriage screw and knob handle secur-
ing the hydro bypass arm to the frame (Fig. 458).
Fig. 458 IMG-0554a
12. Locate the hydro tank vent hose on top of the trans-
axle. Slide the hose clamp up the hose, away from
the transaxle and slide the hose off the transaxle
ÀDQJH)LJ
Fig. 459 IMG-0555a
To Next Page
Loading...
