Toro Workman HDX - Page 115

Workman HD Series Page 6 -- 39 Drive Train
6. Assemble Hi--Lo fork shaft:
A. Install E--ring (item 4) onto fork shaft (item 5).
B. Insert spring (item 3) and steel ball (item 2) into
fork (item 1).
C. Insert fork shaft into fork. Put moly disulfide
grease onto the shaft before installing.
7. Assemble R--1 and 2--3 fork shaft:
A. Insert R--1 fork shaft (item 2) into R--1 fork (item
3).
B. Drive lock pin (item 1) into fork and fork shaft. Pay
attention to direction of slit in lock pin.
C. Insert 2--3 fork shaft (item 2) into 2--3 fork (item 3).
D. Drive lock pin (item 1) into fork and fork shaft. Pay
attention to direction of slit in lock pin.
1
5
4
2
3
Figure 71
Figure 72
Drive Train