Toro Workman HDX - Briggs;Daihatsu Diesel Engine; Engine Throttle Bracket; Workman HDX-D

Workman HDX--D
Page 4 -- 18
Briggs/Daihatsu Diesel Engine
Engine Throttle Bracket
Figure 15
1. Engine
2. Lock nut
3. Cap screw
4. Throttle bracket
5. Flange nut
6. Throttle bellcrank
7. Ball joint
8. Jam nut
9. Threaded rod
10. Accelerator cable
11. Return spring
12. Shoulder bolt
13. Grease fitting
1
4
13
2
3
5
7
6
9
8
11
10
12
FRONT
RIGHT
2
7
8
7
Disassembly (Fig. 15)
1. Remove throttle bracket components from engine as
needed using Figure 15 as a guide.
Assembly (Fig. 15)
1. Install removed throttle bracket c omponents to en-
gine using Figure 15 as a guide.
2. Lubricate bellcrank grease fitting (item 13) after as-
sembly.
3. Check operation and adjustment of accelerator
cable (see Operator’s Manual). If needed, adjust accel-
erator cable.
4. Check engine speed (both idle and high idle) and ad-
just if necessary (see Adjust Engine Speed in Adjust-
ments section of this chapter).