Workman HDX Page 3 -- 3 Briggs/Daihatsu Gasoline Engine
General Information
This Chapter gives information about specifications and
repair of the Briggs & Stratton/Daihatsu 3LC gasoline
engine used in the Workman HDX.
General engine maintenance procedures are described
in your Operator’s Manual. Information on engine trou-
bleshooting, testing, disassembly and assembly is iden-
tified in the Briggs & Stratton/Daihatsu Repair Manual
that is included at the end of this section.
Most repairs and adjustments require tools which are
commonly available in many service shops. Special
tools are described in the Briggs & Stratton/Daihatsu
Repair Manual. The use of some specialized test equip-
ment is explained. However, the cost of the test equip-
ment and the s pecialized nature of some repairs may
dictate that the work be done at an engine repair facility.
Service and repair parts for Briggs & Stratton/Daihatsu
3LC gasoline engines are supplied through your local
Toro distributor.
Operator’s Manual
The Operator’s Manual provides information regarding
the operation, general maintenance and maintenance
intervals for your Workman HDX vehicle. Refer to the
Operator’s Manual for additional information when ser-
vicing the vehicle.
Adding Oil to Engine
When adding oil to the engine, maintain clearance be-
tween the oil fill device and the oil fill opening in the valve
cover (Fig. 1). This clearance is necessary to allow vent-
ing when adding engine oil which will prevent oil from
running into the breather tube and intake system.
Figure 1
CLEARANCE
CLEARANCE
Briggs/Daihatsu
Gasoline Engine
To Next Page
Loading...
