Workman HDX/HDX--DPage 10 -- 4Front Wheel Drive (4WD)
Service and Repairs
CV Axle Assembly
1. Spindle nut
2. CV axle assembly
3. Differential assembly
4. Flange head screw (4 used)
5. Driveshaft
6. Cap screw
7. Flat washer
8. Wheel hub assembly
9. Tie rod assembly
10. Axle spacer
11. Flange head screw
12. Brake caliper (LH shown)
13. Brake rotor
14. Slotted hex nut
15. Cotter pin
16. Knuckle (LH shown)
Figure 1
FRONT
RIGHT
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
35 to 40 ft--lb
(48to55N--m)
35 to 40 ft--lb
(48to55N--m)
170 to 180 ft--lb
(231 to 244 N--m)
ANTISEIZE
LUBRICANT
ANTISEIZE
LUBRICANT
1
2
10
8
11
16
Disassembly (Fig. 1)
1. Park vehicle on a level surface, shut engine off, re-
move key from ignition switch and apply parking brake.
2. For CV axle to be removed, remove wheel assembly,
brake c aliper and brake rotor (see Brake System Disas-
sembly in the Service and Repairs section of Chapter 7
-- Chassis).
3. Remove spindle nut (item 1) from the threaded shaft
of the CV axle. Discard spindle nut.
4. Using wheel hub hole to access flange head screws
(item 11), r emove screws that secure wheel hub to
knuckle. Slide wheel hub assembly from CV axle.
5. Remove axle spacer (item 10) from CV axle.
To Next Page
Loading...
