Toro Workman HDX - Transaxle Assembly

Workman HD Series Page 6 -- 37 Drive Train
Transaxle Assembly
NOTE: Item numbers in figures are shown in reverse
order of assembly; for example, when assembling,
installitem1last.
1. Clean gasket material from all mating surfaces be-
fore reassembling. Make sure all parts are clean and
free of dirt and dust.
IMPORTANT: Be careful not to damage mating sur-
faces when removing gasket material.
2. Assemble L.H. axle shaft:
A. Install new oil seal (item 7) into differential carrier.
B. Use a press to install bearing (item 6) onto L.H.
axle shaft.
C. Install washer (item 5) and snap ring (item 4).
D. Install L.H. axle shaft assembly into differential
carrier.
E. Install snap ring (item 2).
F. Install new O--ring (item 1). Apply multi--purpose
grease on O--ring before installing.
3. Assemble R.H. axle shaft:
A. Install new oil seal (item 5) into seal cover. Apply
multi--purpose grease on O--ring before installing.
B. Insert washer (item 6).
C. Use a press to install bearing (item 4) onto R.H.
axle shaft.
D. Install washer (item 3) and snap ring (item 2).
E. Install R.H. axle shaft assembly into seal cover
(item 7).
4. Assemble differential fork shaft:
A. Drive two (2) lock pins ( item 6) into fork shaft (item
7). Make sure lock pins are installed with slit facing
the correct direction.
B. Install fork ( item 5), spring (item4), washer (item
3) and snap ring (item 2) onto fork shaft using a
press. Apply moly disulfide grease onto fork portion
of fork shaft before installing.
C. Install new O--ring (item 1). Apply multi--purpose
grease on O--ring before installing.
L.H. SHAFT
R.H. SHAFT
Figure 65
ARM
LOCK PIN
Figure 66
Drive Train