Toro Workman HDX - Page 133

Workman HD Series
Page 6 -- 57
Drive Train
10.Disassemble PTO intermediate shaft:
A. Use a bearing puller to r emove bearing (item 1) if
necessary.
11 . Disassemble PTO output shaft:
A. Use a bearing puller to remove bearing (item 1).
B. Remove gear (item 2) and retaining r ing (item 3).
C. Remove retaining ring (item 4) and thrust washer
item 5).
D. Use a bearing puller to remove bearing (item 6) if
necessary.
12.Disassemble shift arm:
A. Remove two (2) lock pins from shift arm.
B. Remove two (2) O--rings (item 1).
1
Figure 121
Figure 122
1
2
3
7
6
4
5
Figure 123
1
Figure 124
Drive Train