Toro Workman HDX - Page 260

Workman HD SeriesPage 9 -- 46Hydraulic System
Steering Control Valve
1. Lock nut
2. Flat washer
3. Steering wheel
4. Steering control valve
5. Hyd hose (to control valve P port)
6. Hyd hose (to control valve E port)
7. Hyd hose (to control valve T port)
8. Hyd hose (to control valve R port)
9. Hyd hose (to control valve L port)
10. Cap screw (4 used)
11. Dust cover
12. Steering hose cover
13. Cable tie
14. Bulkhead fitting (to valve L port)
15. Bulkhead fitting (to valve R port)
16. Bulkhead fitting (to valve T port)
17. Bulkhead fitting (to valve P port)
18. Bulkhead fitting (to valve E port)
19. Hyd hose (to steer cyl shaft end)
20. Hyd hose (to steer cyl barrel end)
Figure 36
FRONT
RIGHT
1
2
3
4
5
6
7
8
9
10
11
12
13
19
20
Antiseize
Lubricant
20 to 25 ft--lb
(28to33N--m)
14
15
16
17
18
Removal (Fig. 36)
1. Park vehicle on a level surface, s hut engine off and
engage the parking brake. Remove key from the ignition
switch.
2. Remove steering wheel (see Steering Wheel Re-
moval in the Service and Repairs section of Chapter 7
-- Chassis).
3. Remove cable ties that secure steering hose cover
to hydraulic hoses. Remove cover from hoses.
4. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of this chapter section.