Toro Workman HDX - Page 99

Workman HD Series Page 6 -- 23 Drive Train
7. Loosen and remove fifteen (15) flange head screws
and separate center plate from transaxle case. Note
dowel pins in transaxle case. Remove s eal cap (item 1),
shims (items 2 and 4) and snap ring (item 3) from center
plate.
8. On 4WD units, r emove front drive shaft and 41T
gear from the gear case. Remove bearings from gear
case (Fig. 29, item 2) and center plate.
9. Remove reverse shaft (item 1) from transaxle case.
10.Remove main shaft assembly (item 1) together with
fork shaft assembly (item 2) from transaxle case.
1
3
2
4
Figure 27
41T GEAR
FRONT DRIVE
SHAFT
BEARING
(GEAR CASE)
BEARING
(CENTER PLATE)
Figure 28
1
2
Figure 29
1
2
Figure 30
Drive Train