Toshiba 3000 PROFIBUS - Assigning Cyclic Data

6F8C0921
45
9.5 Registration and Setup Procedure (Engineering Tool Ver. 1)
9
9.5.3 Assigning Cyclic Data
Assign PROFIBUS cyclic data to variables and I/Q registers in the S controller. This
enables the S controller to process cyclic data as variables or I/Q registers. Use the Scan
data symbol editor 2 to assign cyclic data to variables.
(1) Select [View] - [Symbol Editor 2] in [Product View].
Click the [Read Server] button to read from the database and select a LAN.
Figure 9-10 Symbol editor 2