Need help?Do you have a question about the Toshiba B-443 and is the answer not in the manual?
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Resolution | 203 dpi |
| Max. Print Width | 104 mm |
| Interfaces | Serial (RS-232) |
| Scanning Method | Not applicable |
| Scanning Resolution | Not applicable |
| Scanning Distance | Not applicable |
| Scanning Width | Not applicable |
| Scanning Speed | Not applicable |
| Supported Barcodes | Code 39, Code 128, UPC-A, UPC-E, EAN-13, EAN-8, ITF, Codabar, QR Code, Data Matrix, PDF417 |
| Power Supply | AC 100-240V, 50/60 Hz |
| Operating Temperature | 5°C to 40°C (41°F to 104°F) |
| Storage Temperature | -20°C to 60°C (-4°F to 140°F) |
| Humidity | 20% to 85% (non-condensing) |
Explains symbols used in the manual to convey warnings and precautions.
Lists essential safety measures for operating and maintaining the printer to prevent injury or damage.
Provides step-by-step instructions for initial printer placement and connection.
Guides users on how to load label media and set up the printer for printing.
Details the procedure for correctly installing the thermal transfer ribbon.
Outlines the steps to perform a self-test for printer diagnostics and calibration.
Details the self-test process, including calibration and internal settings check.
Explains how to calibrate the gap sensor for accurate media detection.
Lists common error messages and their potential causes and solutions.
Provides solutions for common problems encountered during printer operation.
To Next Page