Toshiba B-SA4TP SERIES - USB interface; LAN

APPENDIX 2 INTERFACE ENGLISH VERSION EO1-33048
APPENDIX 2 INTERFACE
EA2- 3
 USB interface
Standard: Conforming to V2.0 Full speed
Transfer type: Control transfer, Bulk transfer
Transfer rate: Full speed (12M bps)
Class: Printer class
Control mode: Status with the receive buffer free space information
Number of ports: 1
Power source: Self power
Connector: Type B
Pin No. Signal
1 VCC
2 D-
3 D+
4 GND
 LAN
Standard: IEEE802.3 10BASE-T/100BASE-TX
Number of ports: 1
Connector: RJ-45
LED status: Link LED
Activity LED
LAN cable: 10BASE-T: UTP category 3 or category 5
100BASE-TX: UTP category 5
Cable length: Segment length Max. 100 m
LED LED Status LAN status
ON 10Mbps link or 100Mbps link is detected. Link
OFF No link is detected.
* Communication cannot be made while
the Link LED is off.
ON Communicating Activity
OFF Idle
N
OTE
S
:
1. For IP address setting, refer to Section 2.7.3 IP Address Setting (TCP/IP).
2. When a generally-used twisted pair Ethernet (TPE) or UTP cable is used, a communication error ma
y
occur depending on your operating environment. In such case, you may be requested to use a shielde
d
twisted pair cable.
Link LED (Green)
A
ctivity LED (Orange)
Series B Plug