Toshiba B-SA4TP SERIES - Page 38

2. PRINTER SETUP ENGLISH VERSION EO1-33048
2.7 Setting an Operating Environment
E2-24
2.7.1 Parameter Setting
(Cont.)
(13) KANJI Code Selection
This parameter is to choose a KANJI code.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a Kanji code, press the [PAUSE] key.
(14) EURO Code Selection
This parameter is to choose a Euro code (€).
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a Euro code, press the [PAUSE] key.
NOTE:
K
anji code selection is not supported
by the QM model as the Kanji ROMs
are not installed.
NOTE:
P
ressing the [FEED] or
[RESTART
]
key causes 1 byte
change in the Euro Code value.
<2>PARAMETER SET
KANJI CODE TYPE1
KANJI CODE TYPE1
KANJI CODE TYPE2
[RESTART]
[FEED]
Windows code
Original code
<2>PARAMETER SET
EURO CODE B0
[RESTART]
[FEED]
EURO CODE 20
EURO CODE 21
EURO CODE FE
EURO CODE FF