2. PRINTER SETUP
ENGLISH VERSION EO1-33062
2.8 Loading the Ribbon
E2-14
2.8 Loading the Ribbon
(Cont.)
5. Pull the leader tape of the ribbon downward, and feed it under the
Print Head.
6. Attach the leader tape to the Paper Core with adhesive tape.
7. Rotate the Paper Core to take up the ribbon leader tape until it is
thoroughly covered by the black section of the ribbon.
8. Close the Ribbon Access Cover and Top Cover.
NOTES:
1. Take up any slack in the
ribbon.
2 Do not load a ribbon when
using a direct thermal media.
Print Head
Ribbon Roll
Paper Core
To Next Page
Loading...
Need help?
General
