Why does pressing the FEED key result in an error on my Toshiba Barcode Reader?
If pressing the [FEED] key in the initial state results in an error on your Toshiba Barcode Reader, it is because a feed was attempted contrary to the default conditions. Change the print condition by using the printer driver or a print command so that it corresponds to your printing conditions. Clear the error state by pressing the [RESTART] key.
What causes RIBBON ERROR on Toshiba B-EX6T3 TS?
A 'RIBBON ERROR' on your Toshiba Barcode Reader can occur if the ribbon is not fed or loaded properly, or if the ribbon sensor has a problem. Remove the ribbon and check its status, replacing it if necessary. If the problem persists, turn off the printer and contact an authorized service representative.
What does SYNTAX ERROR mean on Toshiba B-EX6T3 TS?
A 'SYNTAX ERROR' on your Toshiba Barcode Reader means that while the printer is in Download mode for upgrading the firmware, it received an improper command. Turn the printer off, and then on again.
How to fix NO PAPER error on Toshiba Barcode Reader?
If your Toshiba Barcode Reader shows a 'NO PAPER' error, it could be due to a few reasons: the media has run out, it's not loaded correctly, the sensor position needs adjustment, the sensor isn't calibrated, or the media is slack. First, load new media or reload it correctly, and then press the [RESTART] key. If that doesn't work, adjust the sensor position and take up any slack in the media.
What to do if Toshiba B-EX6T3 TS Barcode Reader says PASSWORD INVALID Please Power OFF?
If your Toshiba Barcode Reader displays 'PASSWORD INVALID Please Power OFF', it means a wrong password was entered three consecutive times. Please consult the system administrator.
What to do for other error messages on Toshiba Barcode Reader?
For other error messages on your Toshiba Barcode Reader, a hardware or software problem may have occurred. Turn the printer off and then on.
What does MEMORY FULL mean on Toshiba B-EX6T3 TS Barcode Reader?
If your Toshiba Barcode Reader displays 'MEMORY FULL', it means saving failed due to insufficient storage space in the flash ROM/USB memory. Turn the printer off, and then on again.
What does EEPROM ERROR mean on my Toshiba B-EX6T3 TS Barcode Reader?
An 'EEPROM ERROR' on your Toshiba Barcode Reader means that data cannot be properly read from or written to a backup EEPROM. To resolve this, turn the printer off, and then on again.
What to do when Toshiba B-EX6T3 TS displays NO RIBBON?
If your Toshiba Barcode Reader displays 'NO RIBBON', it means the ribbon has run out. Load a new ribbon and press the [RESTART] key.
Why is the printed image blurred on my Toshiba Barcode Reader?
If the printed image from your Toshiba Barcode Reader is blurred, the combination of the ribbon and media might not be correct, or the print head might be dirty. Select an appropriate ribbon for the media type being used. Clean the print head using the Print Head Cleaner or a cotton swab slightly moistened with ethyl alcohol.
Provides essential precautions for safe and optimal printer placement.
Covers the procedures and safety for loading media and ribbons.
Step-by-step guide for properly loading various media types.
Instructions for correctly loading thermal transfer ribbons.
Routine maintenance steps to ensure print quality and printer longevity.
Specific instructions for cleaning critical internal components.
Lists common error messages and their potential causes and solutions.
Addresses general issues encountered during printer operation.
Detailed procedure for safely clearing media jams.
General| Brand | Toshiba |
|---|---|
| Model | B-EX6T3 TS |
| Category | Barcode Reader |
| Language | English |
To Next Page