7. SUPPLY SPECIFICATIONS ENGLISH VERSION
7.1 Media
E7-1
7. SUPPLY SPECIFICATIONS
7.1 Media
Please make sure that the media being used is approved by TOSHIBA TEC. The warranty does not apply when a
problem is caused by using media that is not approved by TOSHIBA TEC.
For information regarding TOSHIBA TEC approved media, please contact a TOSHIBA TEC authorized service
representative.
7.1.1 Media Type
Two types of media can be loaded for this thermal transfer and direct thermal printer: label or tag. The table
b
elow shows size and shape of the media available for this printer.
B-EX6T Type1 and Type3
Batch Cutter Peel-off
Pitch
Min. 10mm 26.4mm 25.4mm
Max. 1500mm 1500mm 256mm
label Min. 8mm 20.4mm 23.4mm
Length Max. 1498mm 1494mm 254mm
Width (Backing paper
width)
Min. 50mm 50mm 50mm
Max.
165mm 165mm 165mm
Gap
Min. 2mm 6mm 2mm
Max. 20mm 20mm 20mm
Black mark length
Min. 2mm 2mm 2mm
Max. 10mm 10mm 10mm
Thickness of tag paper or
backing paper that can be
cut
Min.
-
0.08mm
-
Max. - 0.17mm -
Min. cut length - 25.4mm -
Label
Tag paper
Cut position
position
Feed Direction
(on reverse side)
(on reverse side)
To Next Page
Loading...
Need help?
General
