2. PRINTER SETUP ENGLISH VERSION
2.6 Printer Stting
E2-18
2.6.6 Initial Setting Wizard
THE first time the printer is used after opening carton box or after a RAM clear, the initial setting wizard
will start when the power is switched on. This wizard enables setting basic parameters, such as the LCD
language and print mode. The values set with this wizard can be changed in the system mode and also by
command.
Example of the Initial Setting Wizard Operation
RAM clear with QM type
selected
1. Perform a RAM clear.
QM TYPE
CLEAR...
↓
QM TYPE
COMPLETED
Turn off the printer
↓ Power OFF/ON
B-EX Series
Initializing...
↓
2. The initial setting wizard
starts.
STARTUP SETTINGS
PRESS ENTER
↓ [ENTER] key
3. Select a language.
LANGUAGE ENGLISH
▲
ENGLISH
G
ERMAN
▼
Select ENTER:Set
FRENCH
Choose the desired option
with the [UP] or [DOWN] key
and press ENTER to set.
↓ [ENTER] key
4. Print mode
PRINT MODE w/ RIBBON
▲
With RIBBON
Without RIBBON
▼
Select ENTER:Set
Choose the desiredoption
with the [UP] or [DOWN] key
and press ENTER to set.
↓ [ENTER] key
5. Select a calibration type.
CALIBRATE OFF
▲
OFF
LABEL/GAP
▼
Select ENTER:Set
BLACK MARK
Choose the desired option
with the [UP] or [DOWN] key
and press ENTER to set.
6.-1 When an option other than “OFF” is selected for CALIBRATE