Toshiba B-EX6T3 TS User Manual

APPENDIX 1 MESSAGES AND LEDSENGLISH VERSION
APPENDIX 1 MESSAGES AND LEDS
EA1-1
APPENDIX 1 MESSAGES AND LEDS
Appendix 1 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated. : The LED is flashing. : The LED is unlit.
2: %%,%%%,%%%: Remaining memory size of the external memory: 0 to 09,999,999 (in K bytes)
3: ####: Remaining memory size for PC commands storage area in the internal memory: 0 to 3072 (in K bytes)
4: &&&&: Remaining memory size for writable characters storage area: 0 to 3147 (in K bytes)
No.
LCD Message
LED Indicati
on
Printer Status
Restoration by
RESTART key
Acceptance of
Status Request/
Reset Command
ONLINE ERROR Yes/No Yes/No
1
ON LINE


In online mode ----- Yes
ON LINE
 
In online mode (The printer is
c
ommunicating)
----- Yes
2
HEAD OPEN
 
The pri
nt head block is open in online
mode.
----- Yes
3
PAUSE
 
The printer is paused. Yes Yes
4
COMMS ERROR
 
A parity, overrun, or framing error has
occurred during communication
through the RS-232C.
Yes Yes
5
PAPER JAM
 
The media has jammed during paper
feed.
Yes Yes
6
CUTTER ERROR
 
A problem has occurred with the cutter
module.
Yes Yes
7
NO PAPER
 
The media has run out, or the media is
not loaded properly.
Yes Yes
8
NO RIBBON
 
The ribbon has run out. Yes Yes
9
HEAD OPEN
 
Feed or printing was attempted with
the print head block open.
Yes Yes
10
HEAD ERROR
 
There is a problem with the print head. Yes Yes
11
EXCESS HEAD TEMP
 
The print head has overheated. No Yes
12
RIBBON ERROR
 
The ribbon has been torn.
A problem
has occurred with the sensor that
determines the torque for the ribbon
motor.
Yes Yes
13
REWIND FULL
 
The internal rewind unit is full. Yes Yes
14
SAVING####KB/&&&&KB
or
SAVING%,%%%.%%%KB
 
Writable character or PC command
save mode
----- Yes
15
FORMAT####KB/&&&&KB
or
FORMAT%,%%%.%%%KB
 
The storage area is being initialised. ----- Yes
16
NOW LOADING…
 
TrueType font or BASIC program is
being downloaded.
----- Yes
17
MEMORY WRITE ERR.
 
An error has occurred while writing to
flash memory or USB memory.
No Yes
18
FORMAT ERROR
 
An erase error has occurred while
formatting the flash memory or
USB
memory.
No Yes
19
MEMORY FULL
 
Data cannot be stored because the flash
memory or USB memory is full.
No Yes
20
SYNTAX ERROR
(Refer to “Notes”)
 
A command error has occurred while
analyzing the command.
Yes Yes
21
POWER FAILURE
 
A power failure has occurred. No No

Toshiba B-EX6T3 TS Specifications

General

Brand	Toshiba
Model	B-EX6T3 TS
Category	Barcode Reader
Language	English