APPENDIX 1 MESSAGES AND LEDSENGLISH VERSION
APPENDIX 1 MESSAGES AND LEDS
EA1-2
22
EEPROM ERROR
Data cannot be read from/written to a
backup EEPROM properly
No No
23
SYSTEM ERROR
When the following abnormal
o
perations are performed, a system
error occurs:
(a) Command fetch from an incorrect
address.
(b) Access to word data at an
incorrect address.
(c) Access to long-word data at an
incorrect address.
(d) Access to the area of 80000000H
to FFFFFFFFH in the logic space
in user mode.
(e) An undefined instruction in an
area other than a delay slot was
decoded.
(f) An undefined instruction in a
delay slot was decoded.
(g) An instruction to rewrite a delay
slot was decoded.
No No
24
DHCP CLIENT INIT…
DHCP Client is being initialised.
when the DHCP is enabled.)
----- -----
25
RFID WRITE ERROR
The printer did not succeed in writing
data onto an RFID tag after having
retried the specified number of times.
Yes Yes
26
RFID ERROR
The printer cannot communicate with
the RFID module.
No Yes
27
INPUT PASSWORD
The printer is waiting for a
password to be entered.
No No
28
PASSWORD INVALID
A wrong password was entered
three consecutive times.
No No
29
RFID CONFIG ERROR
B-EX700-RFID-U2-EU/US-R,
B-EX700-RFID-U4-EU/US-R, U4
Module preinstall model only RFID
Module’s destination code is not
specified.
No No
30
LOW BATTERY
( Refer to Notes)
RTC Battery is low.
No Yes
31
INTERNAL COM ERR
A hardware error has occurred in the
internal serial interface.
No No
NOTE: When an error message listed above appears on the LCD display please refer to Section 5
TROUBLESHOOTING for a solution.
To Next Page
Loading...
Need help?
General
