Why does pressing the FEED key result in an error on my Toshiba Barcode Reader?
If pressing the [FEED] key in the initial state results in an error on your Toshiba Barcode Reader, it is because a feed was attempted contrary to the default conditions. Change the print condition by using the printer driver or a print command so that it corresponds to your printing conditions. Clear the error state by pressing the [RESTART] key.
What causes RIBBON ERROR on Toshiba Barcode Reader?
A 'RIBBON ERROR' on your Toshiba Barcode Reader can occur if the ribbon is not fed or loaded properly, or if the ribbon sensor has a problem. Remove the ribbon and check its status, replacing it if necessary. If the problem persists, turn off the printer and contact an authorized service representative.
What does SYNTAX ERROR mean on Toshiba B-EP2 Barcode Reader?
A 'SYNTAX ERROR' on your Toshiba Barcode Reader means that while the printer is in Download mode for upgrading the firmware, it received an improper command. Turn the printer off, and then on again.
How to fix NO PAPER error on Toshiba B-EP2?
If your Toshiba Barcode Reader shows a 'NO PAPER' error, it could be due to a few reasons: the media has run out, it's not loaded correctly, the sensor position needs adjustment, the sensor isn't calibrated, or the media is slack. First, load new media or reload it correctly, and then press the [RESTART] key. If that doesn't work, adjust the sensor position and take up any slack in the media.
What to do if Toshiba B-EP2 says PASSWORD INVALID Please Power OFF?
If your Toshiba Barcode Reader displays 'PASSWORD INVALID Please Power OFF', it means a wrong password was entered three consecutive times. Please consult the system administrator.
What to do for other error messages on Toshiba B-EP2 Barcode Reader?
For other error messages on your Toshiba Barcode Reader, a hardware or software problem may have occurred. Turn the printer off and then on.
What does MEMORY FULL mean on Toshiba B-EP2?
If your Toshiba Barcode Reader displays 'MEMORY FULL', it means saving failed due to insufficient storage space in the flash ROM/USB memory. Turn the printer off, and then on again.
What does EEPROM ERROR mean on my Toshiba B-EP2 Barcode Reader?
An 'EEPROM ERROR' on your Toshiba Barcode Reader means that data cannot be properly read from or written to a backup EEPROM. To resolve this, turn the printer off, and then on again.
What to do when Toshiba B-EP2 Barcode Reader displays NO RIBBON?
If your Toshiba Barcode Reader displays 'NO RIBBON', it means the ribbon has run out. Load a new ribbon and press the [RESTART] key.
Why is the printed image blurred on my Toshiba B-EP2?
If the printed image from your Toshiba Barcode Reader is blurred, the combination of the ribbon and media might not be correct, or the print head might be dirty. Select an appropriate ribbon for the media type being used. Clean the print head using the Print Head Cleaner or a cotton swab slightly moistened with ethyl alcohol.
General| Brand | Toshiba |
|---|---|
| Model | B-EP2 |
| Category | Barcode Reader |
| Language | English |
To Next Page