Page 14
B-EX4T1 / B-EX4T2 / B-EX4D2
d) 'Cm/inch counter' reading
Note:
- Status: March 2013, version for B-EX4T1/T2 only.
- FW update for 'cm/inch counter' may be required.
o B-EX4T1-GS/TS series, version: C1.3
o B-EX4T2-GS/TS series, version: C1.2A
- The new/additional 'cm/inch counter' is available for use as soon as the new FW is
installed.
- There is no conversion of the previous counter reading in 0.1 km in
MAINTENANCE CONT.
- The '0.1 km' counter in MAINTENANCE CONT is not added to the 'cm/inch
counter.’
1. The system is in ONLINE mode
when switched on.
2. Press the [PAUSE] key.
3. [PAUSE] is shown on the display.
4. Press the [ARROW UP]
key and hold it down for 3
seconds. Press the
[CANCEL] key to return to
Normal mode.
5. The counter is shown in 'cm' and 'inch' on
the display.
6. Press the [ENTER] key.
7. The counter reading is printed out. The
Normal mode in Step 1 is shown again
once printing is complete.
To Next Page
Loading...
