INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO15-33002
6. Real Time Clock: B-SA704-RTC-QM-R
6- 1
6. Real Time Clock: B-SA704-RTC-QM-R
B-SA704-RTC-QM-R is an optional real time clock for the B-SX6T/SX8T series, B-SA4TM/SA4TP series
and B-852-QQ/QP-R series.
NOTE: When the B-SA704-IO-QM-R Expansion I/O board or B-SA704-RS-QM-R serial interface board has
already been installed in the printer, the interface cable of the real time clock cannot be connected to the
MAIN PC board. Please remove this optional PC board temporarily, prior to installing the real time clock.
• Packing List
The following parts are supplied with the kit. Make sure you have all items shown below.
Real Time Clock (1 pc.) See NOTE.
SMW-4x8 Screw (1 pc.)
Lithium Battery CR2032 (1 pc.)
Installation Manual (1 copy)
Battery Sticker (1 pc.)
NOTE:
Make sure that the interface cable
is connected to CN1 on the real
time clock.
• Installation Procedure
1. Turn the power off.
2. Open the right side cover and top cover.
Interface
Cable
Top Cover
Right Side Cover
To Next Page
Loading...
