INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO15-33002
7. Expansion I/O Board: B-SA704-IO-QM-R
7- 3
6. Connect the interface cable to CN4 on the MAIN PC board.
7. Attach the supplied blind plate to the back of the printer with the supplied two SMW-3x6 screws.
NOTE: The blind plate is not required to be attached when the optional serial interface board is also installed.
8. Attach the left side cover which was removed in Step 3 to the back of the printer.
CN4
MAIN PC Board
Interface Cable
Expansion I/O Board
SMW-3ｘ6 Scre
To Previous Page
Loading...
