EN
Introduction Connections Basic Setup Playback
Editing
VCR Functions Others
Function Setup
Recording
95
Specifications
Note
The specifications and design of this product are subject to change without notice.
General
VCR video heads Four heads
Power requirements 220–240 V ± 10%, 50 Hz ± 0.5%
Power consumption 35 W
Power consumption (standby) 5.0 W (When “FL Dimmer” is set to “OFF”: 3.3 W)
Weight 4.9 kg
Dimensions (width x height x depth) 435 x 99.5 x 388 mm
Operating temperature 5°C to 40°C
Operating humidity Less than 80% (no condensation)
TV system PAL-I
Recording
Recording format Video Recording (VR) format (DVD-RW only),
Video format (DVD-RW, DVD-R)
+VR format (DVD+RW, DVD+R)
Recordable discs DVD-ReWritable, DVD-Recordable, DVD+ReWritable,
DVD+Recordable
Video recording format
Sampling frequency
Compression format
13.5 MHz
MPEG
Audio recording format
Sampling frequency
Compression format
48 kHz
Dolby Digital
Tuner
Receivable channels IRA-E69 (For analogue channels)
E21-E69 (For DVB-T channels)
Input/Output
Front Panel : (AV3)
Video input
Input level
One RCA connector
1Vp-p (75 Ω)
Audio input
Input level
Two RCA connectors
2Vrms (input impedance: more than 10kΩ)
DV input
DV 4-pin jack
IEEE 1394
Rear Panel :
VHF/UHF antenna input/output terminal VHF/UHF set 75 Ω
Audio input /output Two 21-pin scart sockets (AV1, AV2)
Video input /output
Input /output level
Two 21-pin scart sockets (AV1, AV2)
1Vp-p (75 Ω) each
Component video output
Output level
Three RCA connectors
Y: 1.0Vp-p (75 Ω)
P
B/CB, PR/CR: 0.7Vp-p (75 Ω) each
Audio output
Output level
Two RCA connectors
2Vrms (output impedance: 680 Ω)
Digital audio output
Output level
One Coaxial pin jack
500mVp-p (75 Ω)
HDMI output HDMI jack
E9NG1BD_EN.book Page 95 Monday, April 7, 2008 5:54 PM
To Next Page
Loading...
