e-STUDIO160/200/250 PRINTING 8 - 6 December 2002 TOSHIBA TEC
8.4 Disassembly and Replacement
[A] Laser scanner unit
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate and junction block.
2. If a JSP (MJ-5001) or OCT (MJ-5002) is at-
tached to the copier, detach it.
3. Detach the toner cartridge.
4. Detach ozone cover. (See Fig. 2-6-9)
5. Detach paper tray cover. (See Fig. 2-6-10)
6. Remove LVPS. (See Fig. 2-6-31 and 2-6-32)
7. Release 2 hooks and remove duct assembly.
Duct assembly
Hook
Screw
Connector
Clamp
066-1
Laser scanner unit
Fig. 8-4-1
8. Release the clamp and detach one connector.
9. Remove 3 screws and take out laser scanner
unit.
10. Detach the one connector and remove laser
scanner unit.
[CAUTION]
To prevent electrostatic destruction, do not touch
the connector pin when plugging or unplugging the
connector.
Note: When the lens gets dirty, blow away the
dirt with the blower.
Fig. 8-4-2
067-2
Connector
To Next Page
Loading...
