Toshiba e-studio 160 - Removal and Reinstallation of Covers and PC Boards; Cover Removal - Rear, Top, and Scanner Covers

December 2002 TOSHIBA TEC 2 - 21 e-STUDIO160/200/250 OUTLINE OF THE MACHINE
2.6 Removal and Reinstallation of Covers and PC Boards
2.6.1 Removal and reinstallation of covers
Fig. 2-6-1
[B] Top cover
1. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
detach it.
2. If a STP (KK-1600) is attached to the copier,
disconnect the power cable.
3. Detach the manual pocket.
4. Remove 3 screws, release hook, and detach top
cover.
Fig. 2-6-2
Rear cover
Screw
Screw
Hook
Top cover
001
Screw
002
[C] Scanner cover
1. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
open it.
2. Remove 3 screws and detach scanner cover.
[A] Rear cover
1. If a STP (KK-1600) is attached to the copier,
disconnect the power cable.
2. Detach the manual pocket.
3. Remove 9 screws and detach rear cover.
Screw
Fig. 2-6-3
Screw
Scanner cover
003-2
[D] Top cover L
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
2. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
detach it.
3. If a STP (KK-1600) is attached to the copier,
disconnect the power cable.
4. Detach the manual pocket.
5. Detach top cover. (See Fig. 2-6-2)
6. Remove 2 screws, release 2 tabs, and detach
top cover L by lifting in the direction of the arrow.
Fig. 2-6-4
Screw
Tab
Tab
Top cover L
004