Toshiba e-studio 160 - Removal and Reinstallation of Covers and PC Boards; Cover Removal - Top R and Control Panel Covers

e-STUDIO160/200/250 OUTLINE OF THE MACHINE 2 - 22 December 2002 TOSHIBA TEC
[E] Top cover R
1. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
detach it.
2. If a STP (KK-1600) is attached to the copier,
detach it.
3. Detach the manual pocket.
4. Detach top cover. (See Fig. 2-6-2)
5. Remove 3 screws, release 2 tabs, and detach
top cover R by lifting in the direction of the arrow.
Fig. 2-6-5
Tab
Top cover R
Tab
Screw
Screw
005
[F] Control panel front cover
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
2. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
open it.
3. Detach scanner cover. (See Fig. 2-6-3)
4. Remove one screw, release one tab, and detach
control panel front cover.
Screw
Control panel front cover
006-1
[G] Control panel bottom cover
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
2. If an Original Cover (KA-1600PC), ADF (MR-2012),
or the RADF (MR-3011) is attached to the copier,
open it.
3. Detach scanner cover. (See Fig. 2-6-3)
4. Detach control panel front cover.
(See Fig. 2-6-6)
5. Remove 2 screws, release one tab, and detach
control panel bottom cover.
Screw
Control panel
bottom cover
Screw
006-2
Fig. 2-6-6
Fig. 2-6-7